Conical Round Tipper

Conical Round Tipper

The new tipping rear mounted round body "CONICA" was created to meet an increasing demand for tippers capable of carrying 19 cubic metres without changing the recognised characteristics of solidity and long life span that made previous models so popular. In fact, the same characteristics in terms of strenght and quality were maintained in the material used to manufacture the sub-frames for ROCCIA dumper models. This means excellent stability during tilting even without the use of mechanical stabilisers.

Weight savings

Weight savings on this equipment were achieved thanks to thorough research into the shape of the load body structure and to the strengthening of the most stressed areas.

We therefore decided to use HB 450 steel not just for the side, front and rear boards of the flatbed area but also for all the other components that make up the base structure and the lateral uprights.

Rear tail lift

The rear tail lift features hydraulically operated gull-wing type opening with two options: full opening as the container is rising and partial opening controlled by the operator depending on needs.

Particular attention was paid to the design of the cab protection so that the cover could be completely retracted to facilitate loading the load body.

Tipping unit

Only the highest quality components are used for the hydraulic system; the capacity of the 116 litre self-compensating pump, the special flanging on the 250 litres distribution system directly to the reservoir through an immersed filter and the use of a 5-stage piston provide a high raising and lowering speed for the load body. Operating pressures of below 140 bar ensure all components will have a long lifespan.

Painting cycles

All structural parts undergo an automated turbine shot-blasting process before they are painted. Since the start of 2007, we have been using cycles of water-based paint and dual component products of the very highest quality, which fully comply with the latest anti-pollution standards.

Accessories

Standard accessories

The set-up is delivered with the mechanically operated Cramaro cover sheet, a stainless steel drawer, the shockproof plastic mudguards, light alloy paracyclist side bars, position side lights, the rear spring bar with two MCTC approved height positions and retro-reflective strips.

The Reinforced Model is produced on request

A second model has the same set-up and finish characteristics with the difference in the thickness of the 6 mm sides. and the 8 mm platform.

Conical Round Tipper

Richiedi informazioni sul prodotto

Compila il form seguente per le tue richieste sul prodotto

Ti risponderemo al più presto

Section
Name (*)
E-mail (*)
Phone
Message (*)
  • Technical features

  • FLOW RATE: FROM 15/17/19 Mᶾ
  • WEAR-RESISTANT STEELS IN CATEGORY HB 450
  • 116 LT SELF-COMPENSATED PUMP FRONT CYLINDER WITH 5 EXTENSIONS
  • WATER GRAINING AND PAINTING TREATMENT
  • Utilizzo Principale

    Ghiaia
    Ghiaia
    Asfalto
    Asfalto
    Sabbia
    Sabbia